I just got knoppix 3.4 with madwifi...
now it works perfect!
Hi,
I'm using Knoppix from CD. I would like to install my DLINK, so i downloaded the madwifi drivers for Atheros chips.
But when i try to load #insmod ath_pci.o i get this error message (i previous loaded wlan.o & ath_hal.o without problem
----
root@ttyp1[madwifi-20030802]# insmod driver/ath_pci.o
driver/ath_pci.o: init_module: No such device
Hint: insmod errors can be caused by incorrect module parameters, including invalid IO or IRQ parameters. You may find more information in syslog or the output from dmesg
----
taking a look dmesg i see
------
ath_pci: 0.8.3.2 BETA (Sam Leffler <sam@errno.com>)
PCI: Found IRQ 5 for device 00:09.0
ath%d: unable to attach hardware; HAL status 13
ath_pci: No devices found, driver not installed.
-----------
any clue? Do you need more info? i am newbie so ask if you need something.
Is it related that doing #make install for madwifi can not write on the ramdisk?
I'm newbie in linux.
Thanks,
Gon.
I just got knoppix 3.4 with madwifi...
now it works perfect!
New Juniper MX204 Router MX204-HW-BASE Junos-64 Dual AC Power
$8750.00
Juniper SRX1500-SYS-JB-AC SRX1500 Services Gateway-Dual Power JPSU-400W-AC
$1784.00
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$40.18
Juniper Networks EX4300-48T 48 Port Gigabit 4 QSFP 40G 2xPSU AFO Network Switch
$89.00
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper Networks EX2300-C 12-Port 2XSFP Uplinks PoE+ Switch P/N: EX2300-C-12P
$299.99
Juniper EX3400-48P 48-Ports PoE+ 4x SFP+ and 2x QSFP+ Managed Switch Tested
$205.00
Juniper Networks EX3400-48T 48 Port Gigabit 4 SFP 1/10G Network Switch #73
$239.99
New Factory Sealed Juniper EX2300-48P Networks 48-Port Managed Ethernet Sealed
$499.00