Hi all,
I'm trying to get ANY distro onto a C3 based board but keep coming up against the CMOV issue, everyone is still compiling for i686 and labelling as i386 it seems. Is knoppix doing the same and is there a version compiled without the requirement for CMOV or am I basically forced into junking this board?
Cheers!
OK, cheers - so from what I can tell i486 should run fine on an eden processor without cmov etc. Thanks, I didn't want to download the ISO to check the config file (limited bandwidth) and wasn't sure where to find an example of it outside there.
Ta
ProLabs 10GBase-TX SFP+ RJ-45 Copper Transceiver Module P/N: SFP-10GBASE-T-C NEW
$34.99
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
Genuine Cisco 74-7747-01 Cisco 10Gbps 10GBase-T Copper 100m RJ-45 X2-10GB-T
$74.99
Cisco Nexus 96-Port 10G SFP+ Switch N9K-93128TX w/ 9K-M12PQ 12-Port 40G QSFP
$149.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$25.99
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$10.99
Genuine Cisco GLC-TE 30-1475-01 V01 1000BASE-T SFP COPPER RJ-45 100M TRANSCEIVER
$11.90
New Sealed Cisco SFP-10G-LR 10GBASE-LR SFP Plug-in GBIC Transceiver module A
$15.80
New Sealed Cisco GLC-TE 1000BASE-T RJ45 SFP Transceiver module *US Shipping*
$20.00