have you found an solution?
you say you see grub, but (I havent used knoppix lately so I can be wrong) knoppix uses LILO nog grub. So what knoppix are you using? and you see grub, what exactly do you see?
Hi,
I am new to the Linux world and KNOPPIX was my first experience with Linux. I was impressed with it and tried to install it on my hdd. All went well until i reboot. I get to the prompt "GRUB" and then nothing happens. Can someone please help me out with this?
Thanks in advance
Cheers,
dantay
have you found an solution?
you say you see grub, but (I havent used knoppix lately so I can be wrong) knoppix uses LILO nog grub. So what knoppix are you using? and you see grub, what exactly do you see?
Hi superstoned,
That was what I thought too. I was baffled to see GRUB prompt greeting me. I THINK that I got over the initial problem I was having. I have had my hdd as the secondary master (there are no primary master or slave, my comp's interior is in a mess and ... I just got too lazy to move my hdd around) and after reading some of the postings, one of them pointed out that I could modify the lilo.conf. So I did and changed boot=/dev/hda to boot=/dev/hdc.
From then on, KNOPPIX loaded ... half way and I get some error message about bad CRC on my hdd and stops. I can't really remember the exact error message right now though. Therefore, I suspect there is something wrong with the hdd but I have been using it for some time and it works.
So, is what I did at the begining (altering the .conf file) the correct thing to do? Or would it have caused some CRC problem (??) to my hdd?
Thanks in advance.
well, its unlikely your disk is broken (or, part of it) but not impossible.
anyway, I'd start moving your hdisk to a propper place (e.g. primary master), it might help. I've seen alot of problems with these things too, esp with raid-hardware present in the system.
and what you did with the conf file is oke, it shouldnt give problems. but you have to re-run lilo for the new config to be applied (guess you did, it worked isnt it?)
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$12.90
Samsung 128GB (4x 32GB) M86B4G70DM0-CMA3 PC3-14900L 4Rx4 DDR3 ECC Reg Server Mem
$39.99
Samsung 16GB 2Rx4 PC4-2400 RDIMM DDR4-19200 ECC REG Registered Server Memory RAM
$20.99
HyperX FURY RAM DDR4 16GB 8GB 32GB 4GB 3200 2666 2400 2133 Desktop Memory DIMM
$9.64
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
Lot of 2 32GB DDR4 2666 PC4-21300 SODIMM RAM Modules Mixed Brand
$60.00
8GB PC3L-12800S 1600MHz SODIMM DDR3 RAM | Grade A
$12.00
A-Tech 256GB 4x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$287.96
A-Tech 128GB 2x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$143.98