Why not read- and writable? I suppose you are using a "poor man's install.
First I boot knoppix as:
then I seeknoppix64 init 2 no3d fromhd="/dev/sdc5"
$ mount | grep mnt-system
/dev/sdc5 on /mnt-system type ext4 (rw,relatime,block_validity,delalloc,barrier,user_ xattr,acl)
$ blkid | grep sdc5
/dev/sdc5: LABEL="KNPX771" UUID="54e317fe-73cf-4b1c-8b1f-dfc9b708b68a" TYPE="ext2" PARTUUID="591ef660-03"
Why not read- and writable? I suppose you are using a "poor man's install.
OK, I (most probably wrongly) thought that partition used for a "poor man's install" would be read-only anyway
Say, you would like to define the regular user directory on the starting command prompt and you don't want anything to be ever written there
In fact, you would run knoppix without a hard drive at all and set up a user account after it started in case you would like to save anything. I would say a few files (access control + security) would be altered, just a few ... but the rest should be read-only
How do you do that?
Last edited by Albretch; 12-19-2016 at 08:03 PM.
In this case I wouldn't use a Live Linux as Knoppix with all his limitations. I would prefer for example Debian.
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
New Cisco w/ Green Hologram GLC-LH-SMD 1G SFP LX 1310nm 10km SMF LC Module
$16.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
(Lot of 10) Cisco SFP-10G-SR SFP+ Transceiver Module 10-2415-03
$40.00
10Gtek ASF-10G-T 10GBase-T 10GbE SFP+ to RJ-45 Copper Optical Transceiver Module
$35.99
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
GENUINE CISCO DS-SFP-FC32G-SW SFP NEW SEALED SEE PHOTOS SHIPS FREE
$69.99
New Sealed Cisco SFP-10G-LR 10GBASE-LR SFP Plug-in GBIC Transceiver module A
$15.80