Why not read- and writable? I suppose you are using a "poor man's install.
First I boot knoppix as:
then I seeknoppix64 init 2 no3d fromhd="/dev/sdc5"
$ mount | grep mnt-system
/dev/sdc5 on /mnt-system type ext4 (rw,relatime,block_validity,delalloc,barrier,user_ xattr,acl)
$ blkid | grep sdc5
/dev/sdc5: LABEL="KNPX771" UUID="54e317fe-73cf-4b1c-8b1f-dfc9b708b68a" TYPE="ext2" PARTUUID="591ef660-03"
Why not read- and writable? I suppose you are using a "poor man's install.
OK, I (most probably wrongly) thought that partition used for a "poor man's install" would be read-only anyway
Say, you would like to define the regular user directory on the starting command prompt and you don't want anything to be ever written there
In fact, you would run knoppix without a hard drive at all and set up a user account after it started in case you would like to save anything. I would say a few files (access control + security) would be altered, just a few ... but the rest should be read-only
How do you do that?
Last edited by Albretch; 12-19-2016 at 08:03 PM.
In this case I wouldn't use a Live Linux as Knoppix with all his limitations. I would prefer for example Debian.
LSI 9305-16i SATA SAS 12Gbs RAID Controller PCIe 3.0 x8 IT-Mode 4* 8643 SATA
$229.99
Lot of 2 -Dell P2R3R PERC H330 Mini Mono 12Gbps SAS Non-raid Controller 0P2R3R
$39.99
XDHXT DELL PERC H710P 6Gbps 1GB PCI RAID CONTROLLER 0XDHXT
$59.00
HPE 727263-003 BL460c G9 Raid BBWC Smartstorage Battery
$24.99
Inspur LSI 9300-8i Raid Card 12Gbps HBA HDD Controller High Profile IT MODE
$15.98
ORICO Multi Bay RAID Hard Drive Enclosure USB 3.0/ Type-C For 2.5/3.5'' HDD SSDs
$86.99
Inspur LSI YZCA-00424-101 Raid Card 12Gbps HBA Controller Low Profile 9300-8i IT
$15.98
LSI MegaRAID 9361-8i 12Gbps PCIe 3 x8 SATA SAS 3 8 Port RAID + BBU & CacheVault
$39.00
Lenovo 930-16i PCIe SAS RAID Controller FRU P/N: 01KN508 Tested Working
$149.99
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$58.99