What does memtest86 say after a running time more than six hours?In case of hardware issue ..
Opterion server board, was working happily, then I tried adding a PCI-e USB 3.0 card. Would not reboot after poweron, even if the card is removed.
Goes through bios, hits grub, gets to "Loading kernel", hangs (i.e., ctrl-alt-del does not reset, requries reset or poweroff).
Reset the bios to failsafe defaults, purged nvram, no help: "Loading kernel", newline, hung.
Pulled battery did hardware reset, went into bios, loaded failsafe defaults, ditto.
I've used a unetbootin image of gentoo stage3 to boot his machine before for initial installation.
Tried that, same result: Loading Kernel, newline, hangs.
In case of hardware issue I've stripped the disk controller and drives & riser cards leaving nothing but a bare motherboard + cpu's + memory.
Same result.
Tried Knoppix via unetbootin of KNOPPIX_V7.4.2DVD-2014-09-28-EN.iso.
This is where things get wierd.
Choosing "debug64" from the main menu gives me:
loading /boot/ ... /linux64 OK
loading /boot/ ... /mininit.gz OK
early console setup
early console decompress_kernel
Bootking the Kernel
<hangs>
Choosing "knoppix64" gives slightly different:
Loading ... linux64
Loading ... minirt.gz
early console decompress
decompressing linux Parse ELF done
Booting linux kernel
<hangs>
Choosing "Default" works with:
Loading /ubnkern
Booting linux kernel
<things happen and the system ends up in window manager>
Q: Does anyone know where the documentation for ubnkern, or the differences between choosing knoppix64 or debug64 and Default are described?
Q: Anyone else with an H8DMU+ that has applied any workarounds they can share?
thanks
What does memtest86 say after a running time more than six hours?In case of hardware issue ..
With knoppix running I checked dmesg and there was nothing reported by the memory scrubber.
No, don't start Knoppix! Use the Knoppix Cheatcode "memtest".
In the initial boot phase you'll see the Knoppix emblem with the little penguin and the commandline at the bottom of the screen. Type only memtest after "boot: " in the commandline and press [Enter].
@ lambark
A few .cfg files in the /boot/isolinux folder of ISO image file may interest you a bit. After seeing another successful case of making a bootable usb device with unetbootin, I am curious about how unetbootin works and cannot find a full set of its user's manuals as well. From the brief summaries on its sourceforge website, I guess it is kind of a boot loader installation GUI which uses either Syslinux or GRUB (in general) as the backend. If so, installing the boot loader directly from terminal with appropriate arguments should be feasible in your case. By the way, you could also try out the very first KNOPPIX USB device in question on a less cutting-edge motherboard to see if the glitch is reproducible.
ATB,
This board is Socket-F: old enough to have been out of production for ~5 years. You can't even buy them from Supermicro at this point.
At some point I must have seemed annoyed enough to satisfy the poltergeists: After one last hard-reset (remove battery & short the
leads with a screwdriver) the existing unetbootin+gentoo install loaded the kernel as usual and I'm running again.
Same thumb drive.
Same reset to failsafe defaults.
Same re-configs of fan, etc, in the bios.
Poltergeists.
1U Supermicro Server 10 Bay 2x Intel Xeon 3.3Ghz 8C 128GB RAM 480GB SSD 2x 10GBE
$297.00
SuperMicro Server 505-2 Intel Atom 2.4GHz 8GB RAM SYS-5018A-FTN4 1U Rackmount
$202.49
HP ProLiant Xeon E3-1220L V2 MicroServer Gen8 2.30 GHz 16 GB RAM NO DRIVES
$199.99
HPE ProLiant MicroServer Gen8 Intel Xeon E3-1265L 16GB ECC PCIe x16 4x1TB HDD
$249.99
HPE ProLiant MicroServer Gen10 Plus v2 Ultra Micro Tower Server - 1 x Intel Xeon
$846.19
Supermicro 505-2 Mini-1U Server 5018A-FTN4 16GB 2.4ghz Atom + Rack Ears
$199.00
Microsel Server Tower Supermicro X10SAE E3-1275 V3 @3.5GHz 16GB 509849-001
$149.99
Supermicro 5018A-FTN4 Rack Server - Black
$125.00
SUPERMICRO CSE-512 AMD Opteron Processor 6128, 32GB DDR3 RAM NO HDD
$90.00
1U 20" Short Depth Server Firewall PFSense X11SSH-F Xeon 3.5Ghz 32GB RAM NVME
$247.00