This was moved, as it so obviously belongs in the hdd install forum.
how do I install a swap file If I installed knoppix on a single hard drive??? I did not make a linux swap drive, and dont have any other partitions, I just have the one that has knoppix is installed on.
the knoppix swap file config. program doesnt seem to support this? any have an idea??
This was moved, as it so obviously belongs in the hdd install forum.
Hi,
you can always use a file as swap area; this works as following:
- first open a root shell (from the KNOPPIX menu or otherwise)
- decide where to put the swap file; /var/run/swapfile might be a good place,
but YMMV
- decide how much space the swap file should take (eg 128M)
- create the swap file:
dd if=/dev/zero of=/var/run/swapfile bs=1024k count=128
- create the swap signature:
mkswap /var/run/swapfile
- add the swap file to /etc/fstab as a line containing:
/var/run/swapfile none swap defaults 0 0
- activate the swap file:
swapon -a
If no errors occured, you now should have 128M swap. Check with "top"
or by issueing "cat /proc/swaps"
Ciao,
Thomas
Lot of 10pcs Brocade 57-1000012-01 8Gbps SWL 850nm SFP+ Optical Transceivers
$19.00
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco Meraki MA-SFP-10GB-SR 10G SFP+ SR 850nm 300m LC MMF
$29.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
10Gbps 10GB SFP+SR transceiver for UniFi Switch 16 XG 16port Ubiquiti US-16-XG
$10.99
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00
New HP HPE Aruba J9150D 10G SFP+ LC SR 850nm 300m MMF XCVR Transceiver Module
$49.99