You can try looking at this thread, it helped get my wireless going:
http://www.knoppix.net/forum/viewtop...804&highlight=
I have just installed Knoppix 3.4 nad I am attempting to use a linksys WSUB11 ver2.6. However on boot it is not found. Any help would be greatly appreciated.
You can try looking at this thread, it helped get my wireless going:
http://www.knoppix.net/forum/viewtop...804&highlight=
I have an MSI PC54g, and even though it uses the broadcom chip set, it is not supported. The first way I got it to work was with driverloader but that is a non-free solution. You get to try it for 30 days then you have to purchase the driver or it will stop working.
I then found ndiswrapper and that solved most of my problems. The only problem I hve now is that I have to do the wlan configuration every time I reboot. Give these steps a try and see if this helps
1. On the command line type lspci nad see if your card is detected.
2. If the card shows up here, download and install ndiswrapper
3. You will need the windows drivers for your card.
4. Follow the instructions to load your driver
5. Go to Network/Internet|Network Card configuration
6. Follow the prompts and you should be good to go.
Good luck
Jim
Grandstream GS-HT802 2 Port Analog Telephone Adapter VoIP Phone & Device, Black
$32.00
$199.99
VoIP IP Phone SIP WAN FV6020 Fanvil Gigabit Office Support IAX IAX2
$35.56
LOT OF 4 Grandstream GXP2135 8 Lines Bluetooth Enterprise VoIP Phone URSB-17w
$79.99
Cisco CP-7945G VOIP Phone With Stand & Handset Business IP Phone 7945
$3.00
Grandstream DP720 10 SIP Accounts Full HD Audio Dect Cordless VoIP Telephone
$24.44
Cisco CP-8841 VoIP Phone - Black
$20.00
Grandstream GS-HT802 2 Port Analog Telephone Adapter VoIP Phone & Device, Black
$25.46
REF A-STOCK - Polycom 2200-48450-025 VVX 411 IP VOIP POE Gigabit Telephone
$38.68
LOT OF 10 Cisco CP-7841-K9 VoIP 4-Line Business Phone w/ Stand Handset Cord
$69.99