I had re-installed Knoppix to HD after having a problem with the filesystem. All went o.k. except that I can't boot Linux anymore. It starts the boot process, regognizes disks, installs RAMDISK etc. Last message is
RAMDISK: Compressed image found at block 0
Then it freezes. When I boot from the floppy, it shows the same message but then goes on.
Since my Linux is on the second HD (hdb4), I assume that the configuration wrote the correct LILO in the MBR of hdb.
1. Does that seem to be a reasonable assumption?
2. If so, how do I get lilo to write the current config to the MBR of hda?
Cheers
Cisco Systems NCS2K-20-SMRFS-L optical multiplexor CISCO EXCESS
$3599.00
Cisco WS-C4500X-24X-IPB 4500-X 24P RJ45 10Gbps GE IP Base Switch 1 Year Warranty
$385.00
Cisco IE-3000-8TC Industrial Ethernet 8 Ports Managed Switch 1 Year Warranty
$114.00
Cisco WS-C4948-10GE-S Catalyst 4900 Series Layer4 Managed Switch 1 Year Warranty
$115.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Cisco Catalyst WS-C2960-48TT-L V02 48 Port Fast Ethernet Switch
$34.00
Cisco WS-C4948-10GE-S 4948-10GE 48 Port Gigabit +10GB Switch w single AC 15.0 OS
$99.99
Cisco C9300-48 48 Port Switch Dual PSU W/C9300-NM-8X P/N: C9300-48U-A Tested
$799.99
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W Network Switch
$41.64