Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
$199.99
VoIP IP Phone SIP WAN FV6020 Fanvil Gigabit Office Support IAX IAX2
$35.56
Grandstream GS-HT802 2 Port Analog Telephone Adapter VoIP Phone & Device, Black
$32.00
REF A-STOCK - Polycom 2200-48450-025 VVX 411 IP VOIP POE Gigabit Telephone
$38.68
Cisco CP-7945G VOIP Phone With Stand & Handset Business IP Phone 7945
$3.00
Grandstream DP720 10 SIP Accounts Full HD Audio Dect Cordless VoIP Telephone
$24.44
New Cisco 7945G IP VoIP Gigabit GIGE Telephone Phone CP-7945G -
$24.95
2 Yealink W56H HD DECT Handset for Cordless VoIP Phone No Base
$29.99
CISCO CP-8821 Wireless IP VoIP Phone - Gray - NO BATTERIES
$80.00
LOT OF 4 Grandstream GXP2135 8 Lines Bluetooth Enterprise VoIP Phone URSB-17w
$79.99