Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Cisco ASA5525-FTD-K9 Security Appliance with FirePower Services
$1000.00
SonicWall TZ300 Power Supply Wired Firewall Router Network Security Appliance
$14.50
Ubiquiti Networks USG Unifi Security Gateway Router/Firewall
$29.95
Cisco ASA5505-BUN-K9 Security Appliance 8-Port Ethernet Firewall *FREE SHIPPING*
$49.99
Dell SonicWALL TZ300 | Firewall Security Appliance
$24.99
OPNsense six-port Gigabit router/firewall on Lanner FW-7535 hardware
$69.00
Fortinet Fortiwifi 60D FG-60D Security Appliance Firewall / VPN w/ AC Adapter
$34.97
Fortinet FortiGate 60F | 10 Gbps Firewall Security Throughput (FG-60F)- Open Box
$381.99