.
I think there is a need for some built-in protection in Knoppix 6.7
to prevent the ruination of LiveUSBs that have been given a task that
turns out to be catastrophic.
What I have in mind is the bad result which occurs after starting a
download that proves ultimately too large for the LiveUSB to accommodate.
This ultimately fails, but also renders the LiveUSB inoperable without
extensive repairs or re-installation.
Couldn't there be some built-in surveillance to monitor for this
condition and head it off with some timely warning or corrective action?
Training the operator and/or using a larger USB are not solutions of interest.
@ vkrishn
For example:
I now have about 400 MB unused on my LiveUSB with persistence.
If I were to initiate a 700 MB download, that would proceed
until the device was 'full' at which time I would get a
warning 'no more room on the device'.
At this point the LiveUSB is corrupted and will not reboot
after shutdown. I think some some protection against this condition
is in order.
The few work-arounds I've tried are all harder than simply
re-installing from a previously arranged clone copy of the LiveUSB.
I guess that means using the space on disk directly and not inside the persistent storage.
The reason I asked, I have few usb installation wanted to be careful.
Did you try installing Knoppix in one partition of the disk and persistent/downloads on another partition, to see if the problem still exists?
Here are two ideas:
1. One could change IceWeasel's Edit>Preferences>General>Downloads
FROM: 'Save files to {/home/knoppix/Downloads}'
TO: 'Always ask always ask me where ...'
2. If there is a 'good' answer to 'where' then one might change the
default to that, instead of 'ask me where'.
Leaving IceWeasel set to its download default is asking for trouble
for those downloading into OS media of relatively limited size.
And you cannot reboot with cheatcode "knoppix noimage"? Of course your persistent memory is damaged, but you can use your backup.At this point the LiveUSB is corrupted and will not reboot
after shutdown.
Thanks, Werner.
The 'noimage' approach is one means of RECOVERY that I've used.
What I was searching for here is a means of PREVENTION.
What with the cost of USBs coming down, there's not much
justification anymore for 2 Gb installs like I've championed up to now.
My favorite current configuration is a 16 Gb USB with 2 GB partition
and the remainder formatted ext3 with kn-recombine on it.
I can just as well shift downloads to that partition and not run
into the 'disasters' anymore.
Cheers.
HPE BL460c G9 ProLiant Blade | 2x Xeon E5-2620V3 | NO RAM | P244BR | 2xHDD Tray
$179.00
Dell PowerEdge FX2 FX2S Enclosure - 4x PowerEdge FC640 w/ 8x Gold 6132 112C 1TB
$2699.99
HPE BL460c G9 ProLiant Blade | 2x Xeon E5-2630V3 | 32GB | P244BR | 2x300GB 15K
$299.00
Dell PowerEdge M640 Barebone Server Blade No Hard Drive Trays
$499.00
Dell PowerEdge M640 Blade Server 2x Gold 6138 CPUS 40 Cores 3.70GHz Turbo
$649.99
HP ProLiant BL460c G9 (Gen9) 2x E5-2670V3 12 Core 3.1GHz No Ram or No Drives
$59.98
HP P17342-B21 M750 E2286M CTO BLADE SERVER
$329.95
Dell PowerEdge FX2s CTO Blade 4 Slot 2U Chassis 2x 2000W
$399.00
HP ProLiant BL460c Gen9 Blade 2x E5-2660v4 2.0GHz =28 Cores 128GB P246 650FLB
$286.00
HP ProLiant BL460c G9(Gen9) 2x 10 CORE E5-2660v3 2.6GHz 128GB RAM No SSD
$222.00