Hi,
I'm trying to do a "frugal install" of DSL on a CF-card mounted to IDE as /dev/hdb. It boots fine (loads kernel, scans for USB, CDROM, creates fstab etc.) until it runs into a
cloop: error -5 uncompressing ###some_wierd_block_numbers###
The ###wierd_block_numbers### are the same on every attempt. I transferred all the data from the compact flash drive to an acient 200MB real hard drive, and mounted that instead of the CF drive. This worked smoothly. So it is not a configuration problem. Somehow cloop doesn't like the CF drive.
Any ideas?
wia
Brand New Juniper SRX-SFP-1GE-T 740-013111 Rev 02B
$34.99
BROCADE ICX6610-24F-E 24-port 1 GbE SFP Switch
$75.95
Lot of 2 ProLabs ZX-SFP-CWDM-1470-NC 1000BASE-CWDM 1470nm SMF Transceiver
$210.00
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00
ProLabs 10GBase-TX SFP+ RJ-45 Copper Transceiver Module P/N: SFP-10GBASE-T-C
$19.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
GENUINE Cisco SFP-10G-SR V03 SFP+ GBIC Transceiver Module 10-2415-03
$6.80
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$10.99
Dell SFP 25GB SFP28-25G-SR-G2 AFBR-725TMZ-FT1 Optical Transceiver 0W4GPP
$31.50
Ericsson RDH102406/49 R1A CPRI & 10GbE 194.9 THz R18 I-Temp SFP+ CRTUAFXLAA
$262.50