I had re-installed Knoppix to HD after having a problem with the filesystem. All went o.k. except that I can't boot Linux anymore. It starts the boot process, regognizes disks, installs RAMDISK etc. Last message is
RAMDISK: Compressed image found at block 0
Then it freezes. When I boot from the floppy, it shows the same message but then goes on.
Since my Linux is on the second HD (hdb4), I assume that the configuration wrote the correct LILO in the MBR of hdb.
1. Does that seem to be a reasonable assumption?
2. If so, how do I get lilo to write the current config to the MBR of hda?
Cheers
Cisco SG110 8 Port Gigabit Ethernet Switch SG110D-08-UK
$39.00
Cisco Catalyst 3650 48-Port Managed PoE+ Gigabit Switch WS-C3650-48FS-E
$55.99
Cisco IE-3000-8TC Industrial Ethernet 8 Ports Managed Switch 1 Year Warranty
$114.00
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$419.99
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
Netgear Prosafe GS724T V2 24-Port 10/100/1000 Gigabit Ethernet Network Switch
$27.99
NetGear ProSafe GS748T V4 48-Port Gigabit Smart Switch w/ Ears + Cord
$30.00
Netgear ProSafe S3300-52X-POE+ 48-Port Gigabit PoE+ Stackable Network Switch
$99.99
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$99.97