does knoppix correctly pick up your graphics card and support it? what type of graphics card do you have?
after knoppix runs through its intialization and tries to enter runlevel 5, my monitor shuts off. i can see everything until that point when it tries to start the GUI. i thought it was some ambiguous command in the startup that did it so i started knoppix in runlevel 2 and then tried to use the 'startx' command. it gets into the process of loading the gui, but the screen still shuts off. the cd continues to load the GUI into the memory though. help please.
does knoppix correctly pick up your graphics card and support it? what type of graphics card do you have?
Sometimes happens when the refresh rate is out of the monitors range.
try puting in the rates at boot
knoppix vsync=60 hsync=60 (examples)
yes, everything loads correctly, knoppix has no problem finding my graphics card or monitor. just after "X" loads, my screen wont come on.
have you tried what firebyrd10 said... thats mainly the next problem in line.
does it work now?
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco SFP-10G-T-S 10GBASE-T SFP+, 30m@Cat6a/Cat7, Copper, RJ45
$83.99
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00