does knoppix correctly pick up your graphics card and support it? what type of graphics card do you have?
after knoppix runs through its intialization and tries to enter runlevel 5, my monitor shuts off. i can see everything until that point when it tries to start the GUI. i thought it was some ambiguous command in the startup that did it so i started knoppix in runlevel 2 and then tried to use the 'startx' command. it gets into the process of loading the gui, but the screen still shuts off. the cd continues to load the GUI into the memory though. help please.
does knoppix correctly pick up your graphics card and support it? what type of graphics card do you have?
Sometimes happens when the refresh rate is out of the monitors range.
try puting in the rates at boot
knoppix vsync=60 hsync=60 (examples)
yes, everything loads correctly, knoppix has no problem finding my graphics card or monitor. just after "X" loads, my screen wont come on.
have you tried what firebyrd10 said... thats mainly the next problem in line.
does it work now?
Vintage DEC/CLEARPOINT INC. -QRAM-2 SAB-1 1MB Q-BUS MEMORY MSV11-QA (B2)
$129.99
DEC PDP 8/M PDP 8M / 4 avail / Vintage Digital Equipment Corp /Also DEC PDP 12
$5775.00
DEC DIGITAL Equipment Corp VT220-D2 Vintage CRT Terminal
$215.00
10x Rare Vintage DEC 12-22246-01 VAX BI TRANSITION HEADER ALL 3 BLOCKS INSTALLED
$209.98
Vintage DEC Digital Equipment VT100 Keyboard 70-14653-11 Missing Key Caps
$103.20
Vintage DEC / DIGITAL CLEARPOINT INC COMPUTER BOARD QRAM-11 QBUS Memory PQ
$109.00
Vintage DEC Digital RX 180 AB Dual 5.25" Disk Drive
$149.00
$47.00
Vintage DEC/The Redac mini cabinet front panel Digital Equipment Corp. 19"
$269.99
VINTAGE DEC Digital RK11-D DISK CONTROL M7255 PDP 11 (B1)
$129.99