I solved my own problem....
I am a neophyte when it comes to LINUX. I do use it occasional for programming, etc..., but I never had to configure anything.
I have the iso I burnt to a CD, which I am trying to boot and run. I have WindowsXP installed on my first partition of my first drive. I have a Maxtor 200GB ATA 133 drive which is connected to an ATA PCI card. It does see my drives because I see them listed and their info.
When the system boots I type expert and see what is going on and I wrote down this info:
hde: pio
hde: host protected area => 1
hde: status timeout: {busy}
hde: drive not ready for command
hde: 398297088 sectors (203928 MB) w/ 1819KiB cache CHS = 155114/16/63
I get a similar display for hdf, too.
What is going on and what do I do? I did read some of the posts on here, but none of them were the exact same as my situation. I spent a few hours looking up the info myself. I tried some cheatcodes that I thought would work like nodma, noapic, acpi=off. Nothing works. I really could use the help.
Anyway, thanks for the help in advance.
I solved my own problem....
Knoppix 9.1 Live Linux GNU Bootable USB Flash Drive USA
$19.99
$8.50
Knoppix Live GNU Linux System 9.1 on Bootable CD / DVD / USB Flash Drive
$9.99
New Knoppix 9.2 Pro Bootable Live OS x86 64Bit DVD Linux
$9.97
Linux Knoppix 4.0.2 Installation Disc
$39.99
$12.00
Knoppix Linux Bootable OS v8.6 "Original Live Operating System" 32G USB Stick
$20.30
KNOPPIX 9.1 LINUX INSTALL & LIVE DVD
$9.99
Acer Aspire One 9 inch Netbook ZG5 512MB RAM 8GB SSD HD Knoppix Linux WiFi VGA
$79.99
Knoppix Linux Bootable OS v8.6 "Original Live Operating System" 16G USB Stick
$19.95