I solved my own problem....
I am a neophyte when it comes to LINUX. I do use it occasional for programming, etc..., but I never had to configure anything.
I have the iso I burnt to a CD, which I am trying to boot and run. I have WindowsXP installed on my first partition of my first drive. I have a Maxtor 200GB ATA 133 drive which is connected to an ATA PCI card. It does see my drives because I see them listed and their info.
When the system boots I type expert and see what is going on and I wrote down this info:
hde: pio
hde: host protected area => 1
hde: status timeout: {busy}
hde: drive not ready for command
hde: 398297088 sectors (203928 MB) w/ 1819KiB cache CHS = 155114/16/63
I get a similar display for hdf, too.
What is going on and what do I do? I did read some of the posts on here, but none of them were the exact same as my situation. I spent a few hours looking up the info myself. I tried some cheatcodes that I thought would work like nodma, noapic, acpi=off. Nothing works. I really could use the help.
Anyway, thanks for the help in advance.
I solved my own problem....
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$12.90
Samsung 128GB (4x 32GB) M86B4G70DM0-CMA3 PC3-14900L 4Rx4 DDR3 ECC Reg Server Mem
$39.99
Samsung 256GB (16GBx16) 2Rx4 PC3L-10600R DDR3 ECC RDIMM Server Memory #99
$124.99
Samsung 16GB 2Rx4 PC4-2400 RDIMM DDR4-19200 ECC REG Registered Server Memory RAM
$20.99
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
HyperX FURY RAM DDR4 16GB 8GB 32GB 4GB 3200 2666 2400 2133 Desktop Memory DIMM
$9.64
Kingston KCP424SD8/16 16GB DDR4 2400Mhz Memory RAM
$15.00
M386A8K40BM2-CTD SAMSUNG 64GB (1X64GB) 4DRX4 PC4-2666V DDR4 SERVER MEMORY
$40.91
A-Tech 256GB 4x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$287.96