Hello.
I want to make a machine boot from a hard disk that already has a linux install on it. I basically need to reinstall lilo to the mbr, using the files from /mnt/hda1/boot (chain.b, boot.0300 & boot.b) and /mnt/hda2/etc/lilo.conf.
I am using the knoppix live CD, and if anyone can tell me how, please do so asap!!! I would be very grateful.
Here is my lilo.conf:
delay=40
append="panic=20"
boot=/dev/hda1
map=/boot/map
install=/boot/boot.b
#prompt
#timeout=50
message=/boot/message
linear
default=linux
image=/boot/vmlinuz-2.2.16-22smp
label=linux-mp
read-only
root=/dev/hda4
append="hdc=ide-scsi"
image=/boot/vmlinuz-2.2.16-22
label=linux
read-only
root=/dev/hda4
append="hdc=ide-scsi"
I copied 2 partitions off the drive as I through that the machine would no longer be needed as a RH7 server, and put FC2 on it.
I now find out that the machine is needed in bootable state (quickly!). I have copied the two images of the partition back on to the drive - hda1 which I have as /boot/ and hda2 which I have the rest of the old system on.
If someone can help me with this I would most grateful!
Thanks,
Tom Jermy
Cisco GLC-SX-MM 1000Base SX SFP Transceiver Module 30-1301-02
$5.99
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$314.99
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco w/ Green Hologram SFP-10/25G-LR-S 10/25GBASE-LR SFP28 Transceiver Module
$79.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
Genuine Cisco QSFP-40G-SR-BD 10-2945-02 Transceiver Module
$15.00
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00