Simply put, I have to run the Configure Printers, enter my root password, bring up the configure menu, push okay and then my printer will work. Any idea why it doesn't work automatically on boot? This happens on both my home machine (3.6) and at work (3.7) both are installed to the hard drive. The home printer is local, the work printer is networked.
Cisco w/ Green Hologram SFP-10/25G-LR-S 10/25GBASE-LR SFP28 Transceiver Module
$79.99
Cisco Meraki MA-SFP-10GB-SR 10G SFP+ SR 850nm 300m LC MMF
$29.99
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco GLC-FE-100LX-RGD 100BASE-LX SFP Transceiver Module
$17.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Lot of 10 SFP-GB-GE-T Copper RJ45 10/100/1000Base-T 100m Transceiver Modules
$29.94
(Lot of 10) Cisco SFP-10G-SR SFP+ Transceiver Module 10-2415-03
$40.00
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99