-
Ethernet interface does not work on HDD Knoppix
I installed Knoppix 3.7 on my hard drive with hardware detection. Thinks look good
so far except that the ethernet interface is not working. If I run Knoppix 3.7 from
the CDROM boot, I can get the ethernet interface working with no problem.
When I pull up the KDE menu and select "Knoppix-->Network Interface-->Network
Card Configuration, the message that I get is, "No support network cards found."
Can anyone help me with this?
Similar Threads
-
By brigi in forum Hardware & Booting
Replies: 4
Last Post: 01-26-2006, 05:02 AM
-
By Jolle in forum Hardware & Booting
Replies: 1
Last Post: 12-21-2005, 06:53 PM
-
By gonzo in forum General Support
Replies: 2
Last Post: 03-24-2005, 05:26 PM
-
By paoloskater in forum Networking
Replies: 0
Last Post: 01-24-2005, 03:26 PM
-
By knoppix-accessibility in forum Customising & Remastering
Replies: 3
Last Post: 12-13-2004, 01:26 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Cisco SG300-52-Port Gigabit Managed Rack Mountable Network Switch
$44.95
ARUBA J9772A 2530-48G PoE+ 48 PORT ETHERNET SWITCH W/ RACK EARS J9772-60301
$140.23
HPE ARUBA 2530-24G J9773A PoE+ 24-PORT GIGABIT ETHERNET SWITCH J9773-60201
$93.24
Brocade ICX 7250-48 48-Port Gigabit Ethernet Network Switch | ICX7250-48-2X10G
$50.95
HP ProCurve 2530-48G 48 Port Gigabit Ethernet Network Switch J9775A TESTED
$30.70
Cisco WS-C2950-24 Layer 2 Switch 24-Port 10/100 Catalyst 2950 Series
$25.00
HP 2530-24G 24 Port Gigabit Managed Ethernet Switch - J9776A
$36.00
NETGEAR 48 ports Gigabit Smart Switch GS748T
$35.00
TRENDnet TEG-S17D 16-Port Gigabit Unmanaged Network Switch
$50.00
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$99.97