i am running knoppix 3.7 on two boxes and i have the same issue
i have two network interfaces eth0 and eth1
eth1 is the usb modem to internet
eth0 is network card to local network
every time i boot up i watch the screen info fly by and i can see the network interfaces being brought up and then back grounding?
when i log in and ifconfig all the interfaces are up and running (even control centre agrees) but if i ping a web address nothing happens
i have to go to netcardconfig and re set the eth1 interface (this often causes eth0 to fall out of bed so i have to restart that again)
i run a web server and this is a real pain in the but
can someone help
i am fairly ok with command line work if needed
m
Cisco Systems NCS2K-20-SMRFS-L optical multiplexor CISCO EXCESS
$3599.00
Cisco SG110 24 Port Gigabit Ethernet Switch w/ 2 x SFP SG110-24
$117.00
Cisco RV160 VPN Router 4 Gigabit Ethernet Ports RV160-K9-AR
$80.00
CISCO SFP-10G-ER 10-2531-02 10GBASE-ER SFP+ 10G 1550nm 40km 1PCS
$135.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Cisco Catalyst WS-C2960-48TT-L V02 48 Port Fast Ethernet Switch
$34.00
Cisco WS-C4948-10GE-S 4948-10GE 48 Port Gigabit +10GB Switch w single AC 15.0 OS
$99.99
Cisco Catalyst 3650 48-Port Managed PoE+ Gigabit Switch WS-C3650-48FS-E
$55.99
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W Network Switch
$41.64