-
Junior Member
registered user
Kernel 2.6, xboing too fast
Am I the onli one with this problem?
When booting Knoppix 3.7 with kernel 2.6 or knoppix 3.9, xboing runs too fast.
With kernel 3.4 (Knoppix 3.7) the speed is OK.
I am not the only one, I see it mentioned here:
http://www.knoppix.net/forum/viewtop...er=asc&start=0
But is there a solution?
Similar Threads
-
By Kslip in forum Hardware & Booting
Replies: 2
Last Post: 01-30-2010, 10:36 AM
-
By algernon in forum General Support
Replies: 0
Last Post: 11-16-2004, 01:26 AM
-
By maxxedout in forum Hdd Install / Debian / Apt
Replies: 2
Last Post: 05-16-2004, 08:33 PM
-
By rickenbacherus in forum The Lounge
Replies: 7
Last Post: 03-14-2004, 08:57 PM
-
By bamarob in forum Hdd Install / Debian / Apt
Replies: 0
Last Post: 01-21-2004, 04:10 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Cisco GLC-SX-MM 1000Base SX SFP Transceiver Module 30-1301-02
$5.99
Cisco Nexus 48-Port 10G SFP+ Switch N9K-9396PX w/ 9K-M12PQ 12-Port 40G QSFP
$314.99
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco w/ Green Hologram SFP-10/25G-LR-S 10/25GBASE-LR SFP28 Transceiver Module
$79.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Lot of 10 SFP-GB-GE-T Copper RJ45 10/100/1000Base-T 100m Transceiver Modules
$29.94
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99
New Cisco SFP-10G-LRM 10G SFP+ LRM 1310nm 220m SMF/MMF LC Module
$34.99