gconftool was added for Gnome-based distributions such as Ubuntu, but klik should continue to work fine without it.
I had used Klik numerous times prior to about a month ago, when attempts to install the script as per instructions began to be interrupted by:
sh: line 571: gconftool-2: command not found
I am running Knoppix 4.02, as I was when Klik formerly worked. Have you altered the script to include sw not on Knoppix? I get the same result when running Knoppix 5.0.
Thanks for any help.
gconftool was added for Gnome-based distributions such as Ubuntu, but klik should continue to work fine without it.
You can safely ignore the gconftool-2 message. klik works anyway.
New Juniper MX204 Router MX204-HW-BASE Junos-64 Dual AC Power
$8750.00
Juniper SRX1500-SYS-JB-AC SRX1500 Services Gateway-Dual Power JPSU-400W-AC
$1784.00
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$40.18
Juniper Networks EX4300-48T 48 Port Gigabit 4 QSFP 40G 2xPSU AFO Network Switch
$89.00
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper Networks EX2300-C 12-Port 2XSFP Uplinks PoE+ Switch P/N: EX2300-C-12P
$299.99
Juniper EX3400-48P 48-Ports PoE+ 4x SFP+ and 2x QSFP+ Managed Switch Tested
$205.00
Juniper Networks EX3400-48T 48 Port Gigabit 4 SFP 1/10G Network Switch #73
$239.99
New Factory Sealed Juniper EX2300-48P Networks 48-Port Managed Ethernet Sealed
$499.00