I'm not a networking expert but think its stored under
/etc/init.d/networking
Hi all,
I am installing Gentoo, and using Knoppix to kick-start the install. I have managed to get to the point where I have to define all of the Networking Configuration in Gentoo. In Gentoo, according to the Install Handbook, everything is stored in /etc/conf.d/net. Unfortunately, Knoppix does not have an /etc/conf.d. My question is: where do I look in Knoppix for hints and how do I translate that into Gentoo-speak for all Networking.
Also important: I am currently installing on a box that is connected "directly to the Internet", through DHCP. I expect this one to be easy, as Knoppix detects everything without any trouble or input from me. I will be later doing this on a second box, where I first (under Knoppix) need to run the ADSL/PPPOE configuration - which works fine after I answer Yes to all questions, but where are the "results" stored.
Thank You.
I'm not a networking expert but think its stored under
/etc/init.d/networking
In case anyone is reading this, I found the answer to my question: the settings between the two are not compatible. Fortunately, Gentoo is well documented!
Juniper EX2200-C-12T-2G 12 Port L3 EX2200-C Compact Fanless Switch 1YearWarranty
$195.00
Juniper EX4300-24T Layer 3 24 Ports Manageable Ethernet Switch 1 Year Warranty
$195.00
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$40.18
Juniper Networks EX4300-48T 48 Port Gigabit 4 QSFP 40G 2xPSU AFO Network Switch
$89.00
Juniper Networks EX2300-C 12-Port 2XSFP Uplinks PoE+ Switch P/N: EX2300-C-12P
$299.99
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper EX2300-24P Poe+ Rack Mountable Ethernet Switch
$130.00
Juniper QFX5100-48T-AFO 48 100M/1G/10G Base-T 6 QSFP AFO
$485.00
Juniper EX2300-48P PoE+ Switch 48x 1GbE & 4 SFP+/SFP 10G uplinks, Tested
$289.00