Yes. Can't do any harm, anyway!
Hi, Just ran knx-install.
When in the partitioning section, I create a new primary partition, hda2 (windows is hda1), and a logical hda5, set hda5 to swap. this all goes well. Later I choose to install lilo to mbr. When the install is finished I reboot, but no lilo menu, windowz just bootes up. What am I doing wrong? Should I set hda2 to bootable? (hda1 is marked bootable in cfdisk)
btw it's knoppix 3.2 may 20
Yes. Can't do any harm, anyway!
I was sort of hoping for a yes/no answer
you get aboutOriginally Posted by fingers99
hmm... I created a boot disk during the last install, forgot it was in the drive. So I'm in knoppix at the moment. Is there a tool or script or something to re-install lilo?
Alrighy then! Knoppix is officially up and running here. nice. about bloody time
Seems lilo got a bit weird about my promise controller(not raid) and the 2 hddsks attached to it. I removed the entries from lilo.conf and ran lilo config and presto, lilo installed fine.
Thanks for the quick replies though
/Orv
HP ProLiant DL380 Gen9 8SFF Server - E5-2698 v3 - 32Cores - 128GB Ram - 1TB HDD
$299.00
HP ProLiant ML350 Gen 9 Server 64GB RAM 2.4GHz Xeon 12-Core E5-2667 v3
$300.00
Dell Poweredge R620 2x E5-2680 2.7ghz 16-Cores / 128gb / H710 / 2x Trays / 750w
$199.99
Dell R730xd 26 Port SFF 2x E5-2697v4 36-Cores H730 128GB Server 2x SFP 10G ENT
$490.00
Dell R630 Server 2x E5-2620 V4 2.1GHz =16 Cores 128GB DDR4 1x 960GB 2x 1G 2x 10G
$345.00
Dell PowerEdge R230 1U Server BOOTS Xeon E3-1270 v5 @ 3.60GHz 8GB RAM NO HDDS
$79.99
HP ProLiant DL380 Gen9 Server 1x Xeon E5-2620V3 2.40 GHz 16 GB RAM No OS No HDD
$114.95
Dell PowerEdge R620 Dual Intel Xeon E5-2697 v2 @2.70GHz 128GB RAM No HDD S110
$144.50
DELL PowerEdge R630 8SFF Server 2x E5-2699v3 2.3GHz =36 Cores 64GB H730 4xRJ45
$345.00
Dell PowerEdge R620 Server | 2x E5-2680 V2 2.8GHz | S110 | 128GB RAM | 4x trays
$249.99