# xedit /etc/aumixrc
You can adjust these values- be careful. I run mine at 99. Don't know what maximum is.Code:vol:79:79:P synth:79:79:R pcm:79:79:P speaker:0:0:R line:79:79:R mic:0:0:R cd:79:79:R
I have an IBM A30 Laptop with Knoppix 3.2 installed. When I installed it, it did not detect my soundcard correctly. I ran sndconfig, and it worked.
Now, when I start up, there is no sound. I open mixer, change the levels slightly (they are about 75%, any other level, even lower works) and then sound works for that session, but not on reboot, I have to do the same again.
Any thoughts?
Thanks
# xedit /etc/aumixrc
You can adjust these values- be careful. I run mine at 99. Don't know what maximum is.Code:vol:79:79:P synth:79:79:R pcm:79:79:P speaker:0:0:R line:79:79:R mic:0:0:R cd:79:79:R
I'll try this, but it isn't that the level is too, low, but that I have to change it when the system starts up. Even reducing the volume works. Why should that be?
OIC- perhaps you are not saving your sessions on logout?
How would I know whether I am?
I don't think this is the problem however, since the levels are set at about 75% on startup, there is just no sound, I only need to change them to get sound. Even if I put them back at 75%, it is the act of changing the levels that seems to switch the sound on.
hmmmmmmmm- Are you aware that there are two mixers? kimix & aumix.
To save your sessions on log out:
Control Center>KDE Components>SessionManager
If that doesn't get it working perhaps you should look at your soundcard drivers.
Ah ha, no, I'll check that...
Thanks!
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco w/ Green Hologram SFP-10/25G-LR-S 10/25GBASE-LR SFP28 Transceiver Module
$79.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00