hello all,
i have recently installed knoppix onto my tecra 520cdt, it sports a 20gb HD ,160Mb, 166Mhz MMX CPU and DVD drive. The live CD enabled DMA, but then rebooting from the HD install the DMA has been turned off? any ideas where this should be enabled?
also when in the KDE desktop the HDA1 (8Gb) will not mount properly and shows read only, but my other partitions HDA3 (5GB) and HDA4 (5Gb) are accessible and RW is enabled BTW(HDA2 is my swap 2Gb)
any ideas?
i assume i edit the HDParm area? or in bootmisc.sh
thanks
New Juniper MX204 Router MX204-HW-BASE Junos-64 Dual AC Power
$8750.00
Juniper SRX1500-SYS-JB-AC SRX1500 Services Gateway-Dual Power JPSU-400W-AC
$1784.00
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$40.18
Juniper Networks EX4300-48T 48 Port Gigabit 4 QSFP 40G 2xPSU AFO Network Switch
$89.00
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper Networks EX2300-C 12-Port 2XSFP Uplinks PoE+ Switch P/N: EX2300-C-12P
$299.99
Juniper EX4600-40F-AFI 24 SFP+/SFP Ports 4 QSFP+ Ports Dual AC Switch
$999.00
New Factory Sealed Juniper EX2300-48P Networks 48-Port Managed Ethernet Sealed
$499.00
Juniper Networks EX3300-48T 48-Port PoE+ Gigabit Ethernet Switch 4x SFP+ TESTED
$99.99