have you tried "knoppix xmodule=vesa"?
I have problems to boot Knoppix on my notebook.
I am pretty sure that the reason is the default video driver.
I encountered a similar problem with GParted LiveCD.
A workaround in Gparted LiveCD was to select "Run Forcevideo" and select the VESA driver.
Is something similar possible in Knoppix ?
If yes: Which command is necessary at the boot prompt (which is successfully displayed)?
Alternatively is there a way to add an additional video driver into the ISO image of Knoppix?
My notebook and video card is:
Samsung X20 Notebook (XVM 1730 V)
with 128MB Intel Graphic Media Accelerator GMA 900
with Chipset Intel 915GM/GMS resp Intel 82915GM
Thomas
have you tried "knoppix xmodule=vesa"?
This works !!!Originally Posted by 40below
Thank you
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$37.31
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper EX3400-24T-AC 24 Port Gigabit 4 SFP 10G 2 QSFP 40G Single AC PSU
$149.99
Juniper EX3400-48P 48-Port PoE Gigabit Switch EX 3400 w/ AC - 1 Year Warranty
$175.00
Juniper EX3300-48P 48-Port 10/100/1000BASE-T (48 PoE+ ports) with 4 SFP+
$74.00
Juniper EX3300-48P 48-Port 10/100/1000BASE-T 48 PoE+ 4 SFP+ 750-034250
$50.00
Juniper EX3300-48T EX3300 Series 48-Port 10/100/1000BASE-T no power cord
$40.00
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper Networks SRX345 Service Gateway 8 Port Gigabit 8 SFP 1G
$229.00
Juniper EX4500 40-Port 10GB SFP Managed Ethernet Switch P/N: EX4500-40F-VC1-FB
$199.99