Hi all,
I am new to the forum and here because I have been working on the same project for the past three days. Just today I learned of Knoppix, but I have done alot of research and I feel I have a good grasp on it.
Here's my problem: I purchased an Intel 6300 wifi card (from eBay thinking that I could save some money). Ofcourse the card has a PCI ID that is one digit off from passing the laptop's whitelist. I do however have another laptop without a whitelist that the card is currently in. Knoppix 6.7.0 boots without errors and detects the card (wlan0, I can connect to my wireless network). Yet ethool (root shell) is giving me problems. The two commands I need to use, "ethtool -e wlan0" and "ethtool -E wlan0..." give the error "Cannot get EEPROM data: Operation not supported".
What should I do? Any help would be greatly appreciated. Thanks in advance.
New Juniper MX204 Router MX204-HW-BASE Junos-64 Dual AC Power
$8750.00
Juniper SRX1500-SYS-JB-AC SRX1500 Services Gateway-Dual Power JPSU-400W-AC
$1784.00
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$210.00
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$40.18
Juniper Networks EX4300-48T 48 Port Gigabit 4 QSFP 40G 2xPSU AFO Network Switch
$89.00
Juniper Networks EX2300-C 12-Port 2XSFP Uplinks PoE+ Switch P/N: EX2300-C-12P
$299.99
Juniper Networks EX3300-24P | 24 Port Gigabit Network Switch w/ Power cord
$53.99
Juniper EX2300-24P Poe+ Rack Mountable Ethernet Switch
$130.00
Juniper QFX5100-48T-AFO 48 100M/1G/10G Base-T 6 QSFP AFO
$485.00
Juniper EX2300-48P PoE+ Switch 48x 1GbE & 4 SFP+/SFP 10G uplinks, Tested
$289.00