Hi all,
I'm trying to get ANY distro onto a C3 based board but keep coming up against the CMOV issue, everyone is still compiling for i686 and labelling as i386 it seems. Is knoppix doing the same and is there a version compiled without the requirement for CMOV or am I basically forced into junking this board?
Cheers!
OK, cheers - so from what I can tell i486 should run fine on an eden processor without cmov etc. Thanks, I didn't want to download the ISO to check the config file (limited bandwidth) and wasn't sure where to find an example of it outside there.
Ta
ORICO Multi Bay RAID Hard Drive Enclosure USB 3.0/ Type-C For 2.5/3.5'' HDD SSDs
$179.99
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$55.45
OWC Guardian Maximus Raid Enclosure SATA Hard Drive FireWire
$36.99
Dell 7H4CN PERC H730P Raid Controller Mini Mono12GBPS 2GB NV Cache
$44.99
LSI MegaRAID 9361-8i 12Gbps PCIe 3 x8 SATA SAS 3 8 Port RAID + BBU & CacheVault
$39.00
Inspur LSI YZCA-00424-101 Raid Card 12Gbps HBA Controller Low Profile 9300-8i IT
$15.98
Dell PERC H330 PCIe 3.0 x8 RAID Storage Controller 04Y5H1 High Profile
$13.99
DELL PERC H310 RAID Controller with Cables, OHV52W, 6Gb/s SAS SATA PCIe x8
$19.95
Dell PERC V10 Z0017A SAS-SATA RAID Controller Card No Bracket N4C2D 5R10N
$52.97
Yottamaster 2 Bay USB 3.1 RAID Hard Drive Enclosure For 2.5" SATA HDD SSD UASP
$59.99