-
Dual PIII boots and runs from 7.2.0 CD but after HD Inst hangs on boot
7.2.0 booted and ran fine from the CD.
I did the HD install, and there were no problems.
It says to reboot, so I try to reboot, it starts booting, the Grub screen comes up, has KNOPPIX option, but it hangs after "Booting the Kernel".
I tried adding debug to the boot command, but it says that's invalid...
Any ideas how to diagnose?
PS: the drives are SCSI, but I figured if it can see them and format when booted from CD I would think it can see them ok
thanks
Last edited by thriftee; 01-01-2016 at 10:52 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Cisco Systems NCS2K-20-SMRFS-L optical multiplexor CISCO EXCESS
$3599.00
Cisco SG110 24 Port Gigabit Ethernet Switch w/ 2 x SFP SG110-24
$117.00
Cisco RV160 VPN Router 4 Gigabit Ethernet Ports RV160-K9-AR
$80.00
CISCO SFP-10G-ER 10-2531-02 10GBASE-ER SFP+ 10G 1550nm 40km 1PCS
$135.00
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$83.00
Cisco Catalyst WS-C2960-48TT-L V02 48 Port Fast Ethernet Switch
$34.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$38.99
Cisco WS-C4948-10GE-S 4948-10GE 48 Port Gigabit +10GB Switch w single AC 15.0 OS
$99.99
Cisco C9300-48 48 Port Switch Dual PSU W/C9300-NM-8X P/N: C9300-48U-A Tested
$799.99
Cisco Catalyst 3650 48-Port Managed PoE+ Gigabit Switch WS-C3650-48FS-E
$55.99