-
Trying to use Knoppix 7.6 DVD as rescue in Virtualbox
I am doing a linux course. On a Windows 7 PC I have installed Virtualbox. Inside Virtualbox I have CentOS 6.7 and Ubuntu.
Now is the topic rescue cd. So I have downloaded Knoppix 7.6.1. I can boot the pc with the DVD and get what I guess is the grafical UI of knoppix.
However, when I use Virtualbox and try to start the CentOS virtual machine it starts to boot from Knoppix OK but stops with:
Konnte Disk nicht nach /mnt-system mounten. Starte debugging shell:
sh: can't access tty; job control turned off
Can somebody tell me if this is supposed to work or am I trying the impossible?
Thank you and regards,
Mark
-
Is your virtual machine created as 32 bit ? I run Virtualbox 64 bit on a 64 bit Linux host, and I cannot boot Knoppix on a 32 bit virtual machine, although I specifically choose the 32 bit kernel by wriing "knoppix xkeyboard=dk" when booting. Adding no3d makes no difference. It hangs at "Booting the kernel". On a 64 bit virtual machine I can boot Knoppix 32 bit and 64 bit without problems, even without no3d.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Cisco w/ Green Hologram SFP-10/25G-LR-S 10/25GBASE-LR SFP28 Transceiver Module
$79.99
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco Meraki MA-SFP-10GB-SR 10G SFP+ SR 850nm 300m LC MMF
$29.99
Cisco GLC-FE-100LX-RGD 100BASE-LX SFP Transceiver Module
$17.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Lot of 10 SFP-GB-GE-T Copper RJ45 10/100/1000Base-T 100m Transceiver Modules
$29.94
Genuine Cisco GLC-TE 30-1475-01 V01 1000BASE-T SFP COPPER RJ-45 100M TRANSCEIVER
$11.90
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99
New Cisco SFP-10G-LRM 10G SFP+ LRM 1310nm 220m SMF/MMF LC Module
$34.99