Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco Meraki MA-SFP-10GB-SR 10G SFP+ SR 850nm 300m LC MMF
$29.99
CISCO SFP GLC-GE-100FX 10-2019-02 100Base-FX SFP GBIC Transceiver Module 1pcs
$52.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Genuine Cisco SFP-10G-SR Transceiver Module (10-2415-03)
$5.85
New HP HPE Aruba J9150D 10G SFP+ LC SR 850nm 300m MMF XCVR Transceiver Module
$49.99
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00