Try unpluging the power cord for a few minutes then plug it back in and boot.
Before try with knoppix (sucesful), i reboot my pc.
Now i canīt boot my PC, no signal in the monitor, no boot from floppy or cd.
Why? What i can do?
My PC is DELL pentium 4, ram 128mb, windows 2000.
P.D. Sorry by mi bad english
Try unpluging the power cord for a few minutes then plug it back in and boot.
Well, the good thing is your probbably didn't harm your hard-drive.
I'd bet reseting the CMOS should do the trick but that means cracking the case open(and voiding the warranty). Un-plugging the PC probbably won't do much good because there will be a battery back-up on the motherboard. Hmmm, I'll letyou decide.
L J
Try setting your bios to boot from the hard drive (or put the hard drive before the CD in the boot order).
Strange problem, though.....
Dells always seem to have this problem, search the forums for more discussion. I think maybe there should be a warning for dell users.
I couldn't agree more I don't know how many times I've seen a similar post.Originally Posted by eadz
I unpluged the CPU for one day (before only put on-off the pc) and my pc it is alive again. This avoid open the cpu and remove the battery.
Take note all DELL users for Unplug the cpu.
Tanks all for your support!
P.D. Sorry again by my english.
Hmmmmm- voided warranty just for opening the case? What kind of nonsense is that? No wonder I've never been onclined to buy a Dell. I have had older machines that needed the cord uplugged to reset properly too.Originally Posted by Colonel Sanders
Ihad a similiar problem with my dell 4550, after I set the bios to boot from cd knoppix ran fine. But after I removed the cd and rebooted to windows my computer would not boot. Found that there was an error in the memory module. I had to reseat the memory and then windows booted fine. Just be wary when using knoppix on a dell.
And on a different note I tried to run knoppix on an older compaq and found that the monitor is not compatible with knoppix, a compaq specific problem I am told.
Cisco w/ Green Hologram SFP-10/25G-LR-S 10/25GBASE-LR SFP28 Transceiver Module
$79.99
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco Meraki MA-SFP-10GB-SR 10G SFP+ SR 850nm 300m LC MMF
$29.99
Cisco GLC-FE-100LX-RGD 100BASE-LX SFP Transceiver Module
$17.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
10Gtek ASF-10G-T 10GBase-T 10GbE SFP+ to RJ-45 Copper Optical Transceiver Module
$24.00
Mellanox Original MFM1T02A-SR 10GbE 10GBASE-SR SFP+ Transceiver
$9.00
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99
New Cisco SFP-10G-LRM 10G SFP+ LRM 1310nm 220m SMF/MMF LC Module
$34.99