-
On exit : dirty bit is always set
Earlier versions of KNOPPIX always automatically unmounted any mounted devices on "halt" (init 0) or "reboot" (init 6) if the user had forgotten to do so.
Recently (since at least 7.4.2, maybe a lot earlier) this kind feature was removed; and then, in any future session, attempting to mount an external device, one might get the error message "device not properly unmounted". No problem, easily managed.
But on 8.2.0 I find that the boot device is itself left "dirty". Bu this I mean:
I operate KNOPPIX from a USB boot flash drive /dev/sda1. Every time I start up, if I try
$ dosfsck -r /dev/sda1
then I get
0x41 : Dirty bit is set. Fs was not properly unmounted and some data may be corrupt.
So, on exiting KNOPPIX, not even the boot device (let alone any others mounted during a session) is unmounted. This, surely, is an oversight.
Can anything be done manually just before exit? I tried the obvious "umount /dev/sda1" and "umount /mnt-system" but got the same error message "device is in use".
Any ideas? Thank you for your help!
Fergus
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco Meraki MA-SFP-10GB-SR 10G SFP+ SR 850nm 300m LC MMF
$29.99
CISCO SFP GLC-GE-100FX 10-2019-02 100Base-FX SFP GBIC Transceiver Module 1pcs
$52.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Genuine Cisco SFP-10G-SR Transceiver Module (10-2415-03)
$5.85
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00
New HP HPE Aruba J9150D 10G SFP+ LC SR 850nm 300m MMF XCVR Transceiver Module
$49.99