Boot like this:
boot: knoppix nofirewire
plus any other codes you may need.
Hi,
I use Knoppix on my Laptop and I am very pleased with it. But recently a co-worker wanted to run it on a similar Laptop and it hangs in the hardware detection. Is there a way to tell where it hangs? Booting in (almost) no hardware detection also hangs, as well as the expert mode. We also tried to run the Red Hat 9 Install on his PC, buut it also hangs at loading the ohci1394 driver. Is there a way to tell that Knoppix has the same problem? If the ohci1394 really is the problem, is there a way to prevent its loading?
Thanks,
Lothar
Boot like this:
boot: knoppix nofirewire
plus any other codes you may need.
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$12.90
Samsung 128GB (4x 32GB) M86B4G70DM0-CMA3 PC3-14900L 4Rx4 DDR3 ECC Reg Server Mem
$39.99
Samsung 16GB 2Rx4 PC4-2400 RDIMM DDR4-19200 ECC REG Registered Server Memory RAM
$20.99
Samsung 256GB (16GBx16) 2Rx4 PC3L-10600R DDR3 ECC RDIMM Server Memory #99
$124.99
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
Kingston KCP424SD8/16 16GB DDR4 2400Mhz Memory RAM
$15.00
HyperX FURY RAM DDR4 16GB 8GB 32GB 4GB 3200 2666 2400 2133 Desktop Memory DIMM
$9.64
M386A8K40BM2-CTD SAMSUNG 64GB (1X64GB) 4DRX4 PC4-2666V DDR4 SERVER MEMORY
$40.91
A-Tech 256GB 4x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$287.96