Boot like this:
boot: knoppix nofirewire
plus any other codes you may need.
Hi,
I use Knoppix on my Laptop and I am very pleased with it. But recently a co-worker wanted to run it on a similar Laptop and it hangs in the hardware detection. Is there a way to tell where it hangs? Booting in (almost) no hardware detection also hangs, as well as the expert mode. We also tried to run the Red Hat 9 Install on his PC, buut it also hangs at loading the ohci1394 driver. Is there a way to tell that Knoppix has the same problem? If the ohci1394 really is the problem, is there a way to prevent its loading?
Thanks,
Lothar
Boot like this:
boot: knoppix nofirewire
plus any other codes you may need.
Apple Xserve A1009 14-Bay RAID Network Storage Array Enclosure
$249.99
Oracle 7085209 LSI MegaRAID SAS 9361-8i 1GB Cache 12Gbps SAS/SATA PCIe RAID Card
$28.20
Broadcom LSI 9400-16i Raid card SAS/SATA/NVME SFF-8643 SAS3416 PCIe 3.1 x8 HBA
$155.12
Dell HBA330 12GBPS SAS Internal HBA Controller (NON-RAID) PCIe Card J7TNV 0J7TNV
$40.05
Inspur LSI 9300-8i Raid Card 12Gbps HBA HDD Controller High Profile IT MODE
$15.98
ORICO Multi Bay RAID Hard Drive Enclosure USB 3.0/ Type-C For 2.5/3.5'' HDD SSDs
$86.99
LSI MegaRAID 9361-8i 12Gbps PCIe 3 x8 SATA SAS 3 8 Port RAID + BBU & CacheVault
$39.00
Inspur LSI YZCA-00424-101 Raid Card 12Gbps HBA Controller Low Profile 9300-8i IT
$15.98
Lenovo 930-16i PCIe SAS RAID Controller FRU P/N: 01KN508 Tested Working
$149.99
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$58.99