Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
Oracle 7085209 LSI MegaRAID SAS 9361-8i 1GB Cache 12Gbps SAS/SATA PCIe RAID Card
$28.20
Dell HBA330 12GBPS SAS Internal HBA Controller (NON-RAID) PCIe Card J7TNV 0J7TNV
$40.05
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$58.99
LSI 9305-16i SATA SAS 12Gbs RAID Controller PCIe 3.0 x8 IT-Mode 4* 8643 SATA
$229.99
Inspur LSI 9300-8i Raid Card 12Gbps HBA HDD Controller High Profile IT MODE
$15.98
Inspur LSI YZCA-00424-101 Raid Card 12Gbps HBA Controller Low Profile 9300-8i IT
$15.98
LSI MegaRAID 9361-8i 12Gbps PCIe 3 x8 SATA SAS 3 8 Port RAID + BBU & CacheVault
$39.00
ORICO Multi Bay RAID Hard Drive Enclosure USB 3.0/ Type-C For 2.5/3.5'' HDD SSDs
$86.99
Lenovo 930-16i PCIe SAS RAID Controller FRU P/N: 01KN508 Tested Working
$149.99
Dell 7H4CN PERC H730P Raid Controller Mini Mono12GBPS 2GB NV Cache
$44.99