KNOPPIX is not at fault here, XFree86 is. I think it works from the highest refresh rate provided by the video card (and not the display itself). There may be a cheatcode which will allow you to set a lower rate at the KNOPPIX boot prompt.
-SUO
Hi,
Knoppix 3.3 boots on my pc
but the refresh rate does not fit to my beamer (it flickers!)
then it starts the xsession with 1280x1024 -> my poor beamer rejects this
to see the xsession I enter at boot time
knoppix screen=1024x768 (I type it blind on the first flickering screen)
then xsession comes up
maybe, knoppix could be more conservative when trying the refresh rate at first boot screen
Bye
KNOPPIX is not at fault here, XFree86 is. I think it works from the highest refresh rate provided by the video card (and not the display itself). There may be a cheatcode which will allow you to set a lower rate at the KNOPPIX boot prompt.
-SUO
Cisco w/ Green Hologram SFP-10/25G-LR-S 10/25GBASE-LR SFP28 Transceiver Module
$79.99
Cisco GLC-FE-100LX-RGD 100BASE-LX SFP Transceiver Module
$17.99
Cisco Meraki MA-SFP-10GB-SR 10G SFP+ SR 850nm 300m LC MMF
$29.99
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Cisco GLC-T 1000BASE-T SFP for Copper Genuine
$8.95
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99
New Cisco SFP-10G-LRM 10G SFP+ LRM 1310nm 220m SMF/MMF LC Module
$34.99