I downloaded and burned the new Knoppix 3.3 LiveCD (11-03-03).
The md5 checksum was OK.
The CD boots ok, but after i get the penguin graphic in the upper left
of my screen, I get these errors about "hde: drive not ready for
command" and "hdf: drive not ready for command"
hde and hdf are my two physical hard disks, which are on a Promise TX133
controller card, neither drive is a boot drive.
I have Knoppix 3.2 also, and it boots just fine.
So what could be the issue with 3.3?
I have tried some of the cheatcode kernel options, like failsafe, but it
always stops booting after the above errors.
1TB/2TB USB 3.0 Flash Drive Thumb U Disk Memory Stick Pen PC Laptop Storage lot
$80.39
Type C USB 3.0 Flash Drive Thumb Drive Memory Stick for PC Laptop 1TB 2TB lot
$73.29
USB Flash Drive Memory Stick Pendrive Thumb Drive 4GB, 8GB, 32GB, 64GB 128GB LOT
$249.37
Lot SanDisk USB Flash Drive Cruzer Blade Glade Force Ultra Flair Luxe 3.0 3.1
$149.99
New TESLA OEM Model S,3,X,Y USB Flash Drive for Dashcam & Sentry Mode 128GB
$18.99
Sandisk 16GB 32GB 64GB 128GB Cruzer Blade Flash Drive Memory Stick USB Lot Pack
$4.99
2TB USB 3.0 Flash Drive Memory Photo Stick for iPhone Android iPad Type C 3 IN1
$16.72
Windows 10 64Bit Installation Kit Flash Drive, USB 16GB, Easy Installation
$10.99
Lot USB Flash Drive Memory Stick Pendrive Thumb Drive 2GB,4GB, 8G, 32G, 64G 128G
$217.13
SanDisk Cruzer Glide USB 3.0 16GB 32GB 64GB 128GB 256GB Flash Drive Memory Lot
$276.48