Did you check all boxes on the Save config menu?
Also, did you type 'knoppix floppyconfig' in the boot menu?
The network configuration saves OK for me, but I myself am having some problems with saving the desktop setup
At boottime I want my ip-adres, default gateway, being active.
I thought doing that by saving the config on floppy.
Well, I booted, but no ip-adres and no default gateway.
Then, I create the files /etc/sysconfig/network and /etc/sysconfig/network-scripts/ifcfg-eth0 and put the right parameters in it.
I saved the config again on floppy, but again at boottime no ip-address and no default gateway.
Does anyone know the solution ?
What did I wrong ?
Thanks for your reply !
winterw
Did you check all boxes on the Save config menu?
Also, did you type 'knoppix floppyconfig' in the boot menu?
The network configuration saves OK for me, but I myself am having some problems with saving the desktop setup
Well I'm in here looking about for the same answer. Seems very hard to get info on this subject with any reliability. I also have tried numerous times to save the 5 configuration options check boxes. Hasn't worked AT ALL. Any help with this would be greatly appreciated, as this is the best operating system I've encountered.
~S~
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig UPOE Network Switch, no module
$379.97
ARUBA J9772A 2530-48G PoE+ 48 PORT ETHERNET SWITCH W/ RACK EARS J9772-60301
$125.69
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$99.97
Dell X1018 X-Series Smart Managed Switches 16-Port Gigabit 2-Port SFP Switch
$65.00
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
Cudy 5-Port 10/100Mbps Fast Ethernet Desktop Unmanaged Switch | FS105D
$12.99
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
New 10/100 Mbps 8 Ports Fast Ethernet LAN Desktop RJ45 Network Switch Hub
$11.49
Cisco SG300-10P 10x PoE RJ45 Gigabit Switch SRW2008P-K9 V03 + Power Adapter
$37.49
HPE ARUBA 2530-24G J9773A PoE+ 24-PORT GIGABIT ETHERNET SWITCH J9773-60201
$87.98