have you found an solution?
you say you see grub, but (I havent used knoppix lately so I can be wrong) knoppix uses LILO nog grub. So what knoppix are you using? and you see grub, what exactly do you see?
Hi,
I am new to the Linux world and KNOPPIX was my first experience with Linux. I was impressed with it and tried to install it on my hdd. All went well until i reboot. I get to the prompt "GRUB" and then nothing happens. Can someone please help me out with this?
Thanks in advance
Cheers,
dantay
have you found an solution?
you say you see grub, but (I havent used knoppix lately so I can be wrong) knoppix uses LILO nog grub. So what knoppix are you using? and you see grub, what exactly do you see?
Hi superstoned,
That was what I thought too. I was baffled to see GRUB prompt greeting me. I THINK that I got over the initial problem I was having. I have had my hdd as the secondary master (there are no primary master or slave, my comp's interior is in a mess and ... I just got too lazy to move my hdd around) and after reading some of the postings, one of them pointed out that I could modify the lilo.conf. So I did and changed boot=/dev/hda to boot=/dev/hdc.
From then on, KNOPPIX loaded ... half way and I get some error message about bad CRC on my hdd and stops. I can't really remember the exact error message right now though. Therefore, I suspect there is something wrong with the hdd but I have been using it for some time and it works.
So, is what I did at the begining (altering the .conf file) the correct thing to do? Or would it have caused some CRC problem (??) to my hdd?
Thanks in advance.
well, its unlikely your disk is broken (or, part of it) but not impossible.
anyway, I'd start moving your hdisk to a propper place (e.g. primary master), it might help. I've seen alot of problems with these things too, esp with raid-hardware present in the system.
and what you did with the conf file is oke, it shouldnt give problems. but you have to re-run lilo for the new config to be applied (guess you did, it worked isnt it?)
Vintage Toshiba Dynabook Portege 3440 Pentium III 500MHz laptop Japanese kybd
$60.00
Vintage Toshiba Satellite Pro 400CS Pentium 75MHz laptop parts or repair
$30.00
Vintage DB25 male to female 10 foot serial cable NEW NOS
$5.50
VINTAGE COLUMBIA 6FT SONY POWER CHEATER CORD NEW NEW OLD STOCK 7A-125V RARE
$59.88
Vintage PANASONIC LX-K780 Multi-Laserdisc Player Karaoke **Remote** Tested
$499.99
VINTAGE Microsoft Works Suite 99 w/Certificate of Authenticity PC New Sealed
$34.97
VINTAGE, HARMAN KARDON, MULTIMEDIA COMPUTER SPEAKERS Tested Good
$25.00
Vintage Compaq Armada 100S Laptop
$89.99
Vintage Dell Precision 420 MT - Intel Pentium II 866MHz - 384MB Ram - No HDD/OS
$149.99
Vintage Dell Precision 410 Intel Pentium II 600 MHz 768 MB Ram I No HDD I No OS
$129.99