gconftool was added for Gnome-based distributions such as Ubuntu, but klik should continue to work fine without it.
I had used Klik numerous times prior to about a month ago, when attempts to install the script as per instructions began to be interrupted by:
sh: line 571: gconftool-2: command not found
I am running Knoppix 4.02, as I was when Klik formerly worked. Have you altered the script to include sw not on Knoppix? I get the same result when running Knoppix 5.0.
Thanks for any help.
gconftool was added for Gnome-based distributions such as Ubuntu, but klik should continue to work fine without it.
You can safely ignore the gconftool-2 message. klik works anyway.
2 Vintage MicroNetwork MN1182-10 Resistor Network Gold IC Chip Ceramic
$10.00
Apple MacIntosh LC-Working Vintage
$145.00
Vintage Seagate Legacy 41MB Internal 3600RPM 5.25" (ST251) HDD
$20.00
Vintage Seagate Legacy 41MB Internal 3600RPM 5.25" (ST251) HDD
$20.00
Vintage Seagate Legacy 41MB Internal 3600RPM 5.25" (ST251) HDD
$20.00
Vintage Seagate Legacy 41MB Internal 3600RPM 5.25" (ST251) HDD
$20.00
Magnetic Peripherals Vintage IDE Hard Drive 7731603
$45.00
vintage AMD AM486 DX2-80 DX2-66 SX2-66 gold pin cpu/warranty
$15.99
Vintage Apple IIe Computer A2S2128 (Powers On) Keyboard does not work
$169.99
Vintage Apple Macintosh PowerBook G3 | Untested #08
$50.00