# xedit /etc/aumixrc
You can adjust these values- be careful. I run mine at 99. Don't know what maximum is.Code:vol:79:79:P synth:79:79:R pcm:79:79:P speaker:0:0:R line:79:79:R mic:0:0:R cd:79:79:R
I have an IBM A30 Laptop with Knoppix 3.2 installed. When I installed it, it did not detect my soundcard correctly. I ran sndconfig, and it worked.
Now, when I start up, there is no sound. I open mixer, change the levels slightly (they are about 75%, any other level, even lower works) and then sound works for that session, but not on reboot, I have to do the same again.
Any thoughts?
Thanks
# xedit /etc/aumixrc
You can adjust these values- be careful. I run mine at 99. Don't know what maximum is.Code:vol:79:79:P synth:79:79:R pcm:79:79:P speaker:0:0:R line:79:79:R mic:0:0:R cd:79:79:R
I'll try this, but it isn't that the level is too, low, but that I have to change it when the system starts up. Even reducing the volume works. Why should that be?
OIC- perhaps you are not saving your sessions on logout?
How would I know whether I am?
I don't think this is the problem however, since the levels are set at about 75% on startup, there is just no sound, I only need to change them to get sound. Even if I put them back at 75%, it is the act of changing the levels that seems to switch the sound on.
hmmmmmmmm- Are you aware that there are two mixers? kimix & aumix.
To save your sessions on log out:
Control Center>KDE Components>SessionManager
If that doesn't get it working perhaps you should look at your soundcard drivers.
Ah ha, no, I'll check that...
Thanks!
ProLabs 10GBase-TX SFP+ RJ-45 Copper Transceiver Module P/N: SFP-10GBASE-T-C NEW
$34.99
Lot (10) Dell 0N8TDR 850nm SFP-10G-SR-85C 10Gbs sfp+ FTLX8574D3BNL-FC N8TDR NEW
$68.00
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
New Sealed Cisco GLC-TE 1000BASE-T RJ45 SFP Transceiver module *US Shipping*
$20.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Brand new Cisco GLC-TE 1000BASE-T SFP Copper RJ-45 100m
$19.99
Cisco SFP-10G-LR 10GBASE-LR SFP+ TRASNCEIVER
$99.99
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$10.99
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99
Lot of 20 Genuine CISCO GLC-TE 30-1475-03 GBIC 1000BASE-T RJ-45 SFP+ Transceiver
$180.99