Boot like this:
boot: knoppix nofirewire
plus any other codes you may need.
Hi,
I use Knoppix on my Laptop and I am very pleased with it. But recently a co-worker wanted to run it on a similar Laptop and it hangs in the hardware detection. Is there a way to tell where it hangs? Booting in (almost) no hardware detection also hangs, as well as the expert mode. We also tried to run the Red Hat 9 Install on his PC, buut it also hangs at loading the ohci1394 driver. Is there a way to tell that Knoppix has the same problem? If the ohci1394 really is the problem, is there a way to prevent its loading?
Thanks,
Lothar
Boot like this:
boot: knoppix nofirewire
plus any other codes you may need.
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$95.00
New Precision DWDM SFP+ 10G 80km Tunable Transceiver 50GHz C-Temp DWDM-SFP10G-C
$90.00
Lot (10) Dell 0N8TDR 850nm SFP-10G-SR-85C 10Gbs sfp+ FTLX8574D3BNL-FC N8TDR NEW
$68.00
ProLabs 10GBase-TX SFP+ RJ-45 Copper Transceiver Module P/N: SFP-10GBASE-T-C NEW
$34.99
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$10.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
CISCO SFP-10G-LR SFP TRANSCEIVER MODULE GBIC 10G 10GB SFP - 1 Year Warranty
$39.99
Mellanox Original MFM1T02A-SR 10GbE 10GBASE-SR SFP+ Transceiver
$9.00
New Sealed Cisco GLC-TE 1000BASE-T RJ45 SFP Transceiver module *US Shipping*
$20.00
Cisco Nexus 96-Port 10G SFP+ Switch N9K-93128TX w/ 9K-M12PQ 12-Port 40G QSFP
$149.99