does knoppix correctly pick up your graphics card and support it? what type of graphics card do you have?
after knoppix runs through its intialization and tries to enter runlevel 5, my monitor shuts off. i can see everything until that point when it tries to start the GUI. i thought it was some ambiguous command in the startup that did it so i started knoppix in runlevel 2 and then tried to use the 'startx' command. it gets into the process of loading the gui, but the screen still shuts off. the cd continues to load the GUI into the memory though. help please.
does knoppix correctly pick up your graphics card and support it? what type of graphics card do you have?
Sometimes happens when the refresh rate is out of the monitors range.
try puting in the rates at boot
knoppix vsync=60 hsync=60 (examples)
yes, everything loads correctly, knoppix has no problem finding my graphics card or monitor. just after "X" loads, my screen wont come on.
have you tried what firebyrd10 said... thats mainly the next problem in line.
does it work now?
Juniper Networks EX3300 EX3300-48P 48-Port Gigabit PoE+ Switch
$37.41
Juniper Networks EX3300 EX3300-48P PoE+ 48-Port 4x SFP Gigabyte Ethernet Switch
$59.99
Juniper EX3300-48P 48-Port 10/100/1000BASE-T (48 PoE+ ports) with 4 SFP+
$74.00
JUNIPER EX3400-48P 48x 1GB PoE+ RJ-45 4x 10GB SFP+ 2x 40GB QSFP+, DUAL AC POWER
$168.00
Juniper EX4200-48PX 48-PORT 10/100/1000BASET PoE Ethernet Switch
$50.00
Juniper EX4500-40F-BF-C 40-Port 10Gbe SFP+ Switch
$124.99
Juniper Networks SRX320-POE 6-Port Service Gateway Security Appliance Tested
$149.99
Juniper EX-UM-4X4SFP EX4300 4-port 1GbE/10GbE SFP+ Uplink Module 1YR WARRANTY
$74.00
Juniper EX 4300 EX4300-48P Gigabit Network Switch JunOS 21.4R3-S7 48 Port PoE
$249.00
Juniper EX 4300 EX4300-48P Switch VC DAC Cables 21.4R3-S7 48 Port PoE
$250.00