Have you tried the CD on another PC to make sure you burned a good image?
Hello,
My Knoppix 3.2 won't boot.
First of all i'm not a newbie in Linux (I've already installed dozens of distros)
When the system boots i only get the message:
I've tried all the options described in help. I always get the same message (several times). I also tried booting from diskete and it's always the same.Code:ide-scsi: CoD !=0 in idescsi_pc_intr
My system is:
Pentium II 233
128 MB RAM
GeForce 2 MX
CD-RW Plextor 16x10x40
Help me please.
Have you tried the CD on another PC to make sure you burned a good image?
Did you try "knoppix noscsi" at boot? Did you also try "knoppix failsafe"? If so, what happened?
You can consider me a total noob to this, but I would like to add my 2 cents. I downloaded Knoppix 3.3 and tried to run it with the same problem (ide-scsi: CoD !=0 in idescsi_pc_intr over and over). I also tried Penguin Sleuth version 7-5-2003 (I believe it uses the 3.2 version of Knoppix). That also crashes in much the same way. I have tried noscsi and failsafe to no avail. Both seem to hang up on the IDE CD-ROM drives. The only thing that made me wonder was the fact that I use a Serial-ATA hard drive. I disabled serial-ATA all together in the BIOS, but it did not have an effect. I have tried both CD drives (same channel master and slave) to no effect.
One other thing that it griped at me about was my IRQs. It said that there was a conflict that I should resolve by setting my IRQs in the BIOS (they are PNP right now). A PCI device failed to load because of that (I think), but I didn't figure that to be the main problem.
Sorry I couldn't give an answer to this problem, but I figured maybe my situation would help diagnose the problem. I know this is late (a year after the original post), but maybe someone has found the problem by now.
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99
New Cisco w/ Green Hologram SFP-10G-LR-S 10G SFP+ LR 1310nm 10km SMF LC Module
$34.99
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
NEW FS SFP-10G-T 10GBASE T SFP+ 30M Transceiver Module (Lot of 1)
$39.95
SFP-10G-SR V03 Original CISCO 10-2415-03 850nm 10GBASE-SR SFP+ Multi mode Module
$5.89
New Cisco w/ Green Hologram GLC-TE 1G SFP Copper RJ45 100m Module
$29.99
Genuine Dell Broadcom 57840S 10GbE Quad Port SFP+ Network Adapter JC10M XGRFF
$39.59