Yes. Can't do any harm, anyway!![]()
Hi, Just ran knx-install.
When in the partitioning section, I create a new primary partition, hda2 (windows is hda1), and a logical hda5, set hda5 to swap. this all goes well. Later I choose to install lilo to mbr. When the install is finished I reboot, but no lilo menu, windowz just bootes up. What am I doing wrong? Should I set hda2 to bootable? (hda1 is marked bootable in cfdisk)
btw it's knoppix 3.2 may 20
Yes. Can't do any harm, anyway!![]()
I was sort of hoping for a yes/no answer![]()
you get aboutOriginally Posted by fingers99
![]()
hmm... I created a boot disk during the last install, forgot it was in the drive. So I'm in knoppix at the moment. Is there a tool or script or something to re-install lilo?
Alrighy then! Knoppix is officially up and running here. nice. about bloody time
Seems lilo got a bit weird about my promise controller(not raid) and the 2 hddsks attached to it. I removed the entries from lilo.conf and ran lilo config and presto, lilo installed fine.
Thanks for the quick replies though
/Orv
Fanxiang 4TB 2TB 1TB SSD 550MB/s 2.5'' SATA III Internal Solid State Drive lot
$188.99
New SSD 870 EVO SATA III SSD 1TB 2.5'' Solid State Drive Upgrade PC Laptop 4TB
$59.99
for Laptops 500GB-4TB Internal Solid State Drive Hard Disk 2.5 Inch SSD Drive
$75.18
Fanxiang SSD 4TB 2TB 1TB 512GB SATA SSD 2.5'' III Internal Solid State Drive lot
$108.29
Patriot P210 128GB 256GB 512GB 1TB 2TB 2.5" SATA 3 6GB/s Internal SSD PC/MAC Lot
$19.99
Fanxiang M.2 SATA SSD 2TB 1TB 512GB 256GB SSD Internal M2 Solid State Drive Lot
$21.99
WD BLUE 3D NAND 250GB 2.5" SATA Laptop SSD Solid State Tested,Wiped -WDS250G2B0A
$16.99
Netac 1TB 2TB 512GB Internal SSD 2.5'' SATA III 6Gb/s Solid State Drive lot
$13.99
Netac 2TB 1TB 512GB 240GB Internal SSD 2.5'' SATAIII 6Gb/s Solid State Drive lot
$118.99
Fanxiang 2TB 1TB 512GB 550MB/S MSATA SSD Solid State Drive 6Gb/s PC/Laptop lot
$104.49