-
CD drive goes Idle after brief use
I'm trying to use a Knoppix 3.9 Boot CD to rescue data off of a laptop hard drive (as suggested by a coworker) and it worked perfectly initially, could get into the hard drive and see everything... but after about five minutes of use, the CD drive would idle (flashing LED, no "spin"), which basically froze up my usage of Knoppix. Manually ejecting the CD and popping it back in would restart it for another few minutes and then I would get the idle problem again. Any idea of how to deal with this, or if it's the Knoppix I'm using that's the problem?
Also, anyone who's used it to rescue have any suggestions of the best way to get the data off? it's about 5 gigs of information.
Computer: Dell Inspiron 5100 (still under warranty), with external wireless
Rescue Problem: Registry damaged (trying to rescue data before System Recovery)
-
Administrator
Site Admin-
It certainly sounds like the CD. I would suspect a high speed burn had been done, assuming that you verified that the download was good with the md5 check. A disc burnt at a slow speed from a confirmed good download would likely resolve your issues. If you have 1 gig of RAM available you might also try the toram cheat code to get everything loaded into ram and then your CD can stop spinning all it wants and there will be no problem, but if it's a bad burn then toram may not help.
---
Verifying of md5 checksum and burning a CD at slow speed are important.
-
You were right! It was the CD. Even the toram didn't work, so I got a diff. version on a confirmed-working CD from my coworker and am transferring the files via Konqueror right now. I knew Linux was the fix to all my crap Windows problems. Thanks for your help!
Similar Threads
-
By SaberCat in forum Hardware & Booting
Replies: 2
Last Post: 08-06-2008, 04:23 PM
-
By GottaBuild in forum General Support
Replies: 1
Last Post: 06-01-2006, 10:22 PM
-
By Lintu in forum Hdd Install / Debian / Apt
Replies: 1
Last Post: 10-20-2005, 06:13 PM
-
By mjman in forum Hardware & Booting
Replies: 9
Last Post: 10-25-2004, 09:46 PM
-
By buenafe in forum General Support
Replies: 1
Last Post: 07-01-2004, 01:46 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00
New Cisco w/ Green Hologram SFP-10G-LR-S 10G SFP+ LR 1310nm 10km SMF LC Module
$34.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
NEW FS SFP-10G-T 10GBASE T SFP+ 30M Transceiver Module (Lot of 1)
$39.95
10Gtek ASF-10G-T 10GBase-T 10GbE SFP+ to RJ-45 Copper Optical Transceiver Module
$35.99
NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*
$18.00
New Cisco w/ Green Hologram GLC-TE 1G SFP Copper RJ45 100m Module
$29.99